Free shipping for orders over € 500


LEN LTD LHDS01 HD SDI Splitter

Miniature, broadcast-quality HD SDI passive video Splitter. No power required.
SKU: 1608935
MFR: LHDS01
MODEL: LHDS01
Delivery date: Usually dispatched within 10-12 days
118,43 € excl tax
Availability: In stock

Overview

Miniature, passive designs, requiring no power, LEN SDI splitters are a direct equivalent to the use of a Distribution Amplifier to create additional SDI signals, for most applications. LEN Splitters are also often used for such applications as additional monitor feeds say in remote camera locations, and in situations where size and weight are critical factors, such as racing cars, bikes and other sporting and research applications. Offering a broadcast-quality signal, they are useful in both permanent and temporary installations. They may be used freestanding and have fixing screws for mounting through panels. An accessory panel is also available to mount eight splitters in 1U of rack space.

The LHDS01 may be used with HD or SD SDI. Each is built in an ABS enclosure fitted with three female BNC connectors. All LEN Video Splitters can also be used with the ASI format.

Two or more splitters can be used in series to provide up to eight individual feeds over shorter distances. Actual distance dependant on original signal strength and cable quality.

 

SPECIFICATIONS

 

Input and output impedance: 75 ohms
Return loss: (1) 15dB, 5 to 1485 MHz
Amplitude roll-off, 360 MHz (2): -0.2dB
Amplitude roll off, 1485 MHz (2): -0.5dB

Insertion loss: 3.4dB
Isolation, 270 MHz, (3): 35dB
Isolation, 1485 MHz, (3): 16dB

Drive capability, typical (4): 90 metres
Note 1: Worst case, both outputs terminated. 2: Maximum attenuation. 3: Between output ports. 4: Depends on cable type; 20% reduction compared to a free cable run.
Dimensions: 45 x 30 x 15 (length x width x height) mm, excluding connectors. Weight: 30g.

 

Technical Note
To achieve the specified performance the input should be fed with a source impedance of 75 ohms and both outputs must be terminated with 75 ohms. Therefore, if an output cable is not present, a 75 ohm termination should be fitted. This should be specified to operate over the full SDI bandwidth in use.

Brochures
DEM RUNHDS001 DATASHEET 2006/12 (PDF)

Tipo file: PDF
N Pagine: 1 | Dimensioni: 114Kb

Download
Brochures
LEN LTD HDS01 TECHNICAL DATA (PDF)

Tipo file: PDF
N Pagine: 1 | Dimensioni: 157Kb

Download
Brochures
LEN LTD HDS01 DATA SHEET 2018/11

Tipo file: PDF
N Pagine: 1 | Dimensioni: 475Kb

Download
Brochures
LEN LTD LHDS01 DATASHEET 2020/05

Tipo file: pdf
N Pagine: 1 | Dimensioni: 466Kb

Download